Installing SQUID on a Synology NAS


I’m not going to go into exactly why (it’s a minor networking niggle following on from a change in broadband provider) but I wanted a simple HTTP proxy in my lab so that my lab VMs could get out on to the internet. Mostly for installing updates etc. Since my NAS is ideally placed in my network I thought that I’d use that. It’s only a short-term thing anyway. Now in order to get a proxy service on to the NAS, I needed to setup IPKG first. This allowed me to install and configure SQUID as follows: 1. Open an SSH session to the NAS 2. Download and install SQUID 3. Perform a couple of configuration commands 4. SQUID can now be started using /opt/etc/init.d/S80squid start Now there may be some additional changes you … [Read more...]

How to install IPKG on a Synology NAS


Sometimes you want to install “community” or third party packages on your Synology NAS and they require IPKG (Itsy Package Management System) to be present. Instruction about how to go about this seem to vary and are often specific for the CPU inside your NAS. The easiest method that I’ve found for getting IPKG installed is as follows... First job is to open an SSH session to the NAS and confirm what type of processor it has. This can be done using the following command: For my DS1513+ it returns: Next you need to dig around the site to find the correct bootstrap for your architecture. In my case it’s … [Read more...]

Synology DS1513+ Released


The Synology DS1512 has been a popular choice for many home labs in recent years. I hoped that the company's raft of recent product updates would reach this model eventually. Well my wish was granted as Synology have announced the DS1513+. There are a few modifications to note. The one that stands out the most at first glance is the doubling of LAN capability.  The DS1513+ boasts no fewer than 4 RJ45 ports. That does seem like quite a lot. It does open up some interesting possibilities though... The full specifications for the DS1513+ can be found here. … [Read more...]